The IGBT 2011 is the ultimate Energic Plus® charger and it is the result of 40 years of experience in design, production and customization of chargers for the material handling industry.
The AQ Steam is a “continuous recharge” revolutionary steam cleaner designed and marketed by ENERGIC PLUS.
Charges batteries in the range up to 96 V with an adjustable current between 1 to 50 A. Can be used for on-site assistance, providing improved charging of any battery or replacement of any old charger that may have failed.
The AR Digital is three-phase traction battery charger. The digital technology increases the lifespan, has a built-in maintenance system and is more compact than the older type of chargers, easier to store and transport.
Single-phase high-frequency battery charger BC1 is available in a 12 and 24 V version.
Single-phase high-frequency battery charger NG1 is available at 12 - 24 - 36 - 48 - 72 - 80 - 96 V.
Single-phase high-frequency charger UBC is available in a 12 and 24 V version, with dual input.
Three-phase high-frequency battery charger NG5 is available in these versions: 24 - 36 - 48 - 72 - 80 - 96 V.
Three-phase high-frequency battery charger NGTOP
The RX traction battery charger is a fully automatic, microprocessor-controlled battery charger. It has a compact and simple construction, wit a LED control panel and automatic equalization of the battery.
The single-phase traction battery charger RE is fully automatic and has a microprocessor-controlled electronic card.
The battery regenerator gives your batteries a second life by removing the lead sulphate by an electrical high-frequency pulsation process.
Three-phase high-frequency charger NG9 is available in these versions: 24 - 36 - 48 - 72 - 80 - 96 V.
Single-phase high-frequency charger NG3 is availble in these versions: 12 - 24 - 36 - 48 - 72 - 80 - 96 V.
The MVD multi-voltage traction battery charger is suitable for any type of battery (lead-acid, gel, voltage, capacity). Long time, low constant current.
Multi-voltage traction battery charger MVM
The SMC is a battery charger designed to be mounted on board in battery-powered vehicles (scissor lifts, golf carts, etc.). It has been designed for maximum reliability in wet and dusty environments. For lead-acid and gel-cell batteries.
A discharge test is the only way to properly verify a battery’s capacity, and this can now be performed with the MPD-1007E.